Thursday, 2 March 2023

Pinpoint axle bearing reamers.

 Sometimes when your building a wagon kit, no matter how careful you are, the thing just won't run as well as you'd like because the wheels are tight in the axleboxes. This is where bearing reamers come into play;


The ones above are DCC Concepts N/009 type on the left and an Ultrascale OO/EM/P4 etc. on the right. Here's a closer look at the Ultrascale offering;


Note the cutting edge, on one end only. These are as far as I can tell no longer available, but DCC Concepts do stock similar, in both 26mm and 24.25/25.25mm axle lengths.
The two DCC Concepts jobs in close up;


The left had one has clearance for typical N coupling pockets. These have a different style of cutting edge, which is repeated on both ends of the axle.
In use, in this case on my laser cut van (which never has run particularly freely);


They have improved matters, now the van runs quite easily. My thanks to Neil Moss for flagging up the DCC Concepts reamers on the NGRM-Online forum.

These reamers are really only suitable for use in plastic bearings, but should be useful to us kitbuilders as well as improving any tight RTR stock.


Paul.

Sunday, 26 February 2023

Military Wheels Lublin-51 - finished.

 I've finally finished this tiny lorry.

After joining the main parts together the last few jobs were to paint the sidelights white and fit the mirror and headlights.

Both the headlights and mirror were made on the lathe. Making the lights followed the pattern described here, I did however paint the rear of the lenses silver (Vallejo) and the outer diameter black before attaching (using canopy glue), the black headlight surround is a small but noticeable detail on the prototype. The mirror was turned from brass, 2.2mm dia., with the reflective side recessed by .1mm using a 1.5mm slot drill before being parted off .3mm thick. This was then soldered to a length of .4mm brass rod which was chemically blackened before being painted and fitted into a hole drilled in the upper door hinge on the driver's side.

There is a slight twist in the chassis, so it doesn't sit flat on all four wheels, and the load bed is slightly tilted towards the rear (which I only spotted once it was glued in place), I will just have to live with that. 

I perhaps should have fitted windscreen wipers, but sometimes you need to say "enough" and just finish the thing!


This has been a pretty challenging build, but worthwhile I feel. As usual I've learned a lot, enjoyed researching an obscure (to us) prototype and I now have a model that, although flawed in some respects, I am pleased with.


Finally, one with the photo and owners manual that I found online;


Not the best photos today I'm afraid, but my little photo plank looks pretty good, and I like the effect of the sun playing on the white paper background. Taken in the garden with my aging point and shoot.


Paul.

Saturday, 18 February 2023

Unimat 3 bed protector.

Quite often I will cut off a part on the lathe with a junior hacksaw rather use a parting-off tool, this is kinder to the machine as parting off puts a lot of strain on such a small lathe. However, its easy for the blade to slip as you break through and damage the bed if you're not careful. So, I've made a bed protector from two pieces of 6mm MDF to sit under the chuck and protect the bed from the sawblade should it slip. It will also protect the bed from being bruised by dropped chucks, its easy to drop a chuck when changing them. 

Here it is in position;

And showing the underside;


Not bad for a few minutes work and some MDF offcuts. Now I need to make one for my Unimat SL.

Paul.