These are the main parts;
I'm building the basic shell first, once that's done I'll mount it on the floor/wing moulding.
A closer look at the two sides;
With the front bulkhead;
The two sides glued together;
The fit wasn't actually too bad!
Bulkhead in place;
There's some gaps there but again the fit isn't as bad as I feared.
Radiator/grill being glued on;
Bonnet in place;
The bonnet has been slightly re-profiled, the front where it meets the grill should be lower and I had to shorten it by about half a millimetre.
Cab roof, showing the mould lines;
I reckon that it will clean up without too much filler being used.
Cab rear, lots to do here;
The rear of the wooden cabbed Gaz/Lublin-51s is flat, which will help matters...
The next stage will involve files, wet & dry paper, and filler!
Paul.
No comments:
Post a Comment
Feel free to leave comments but please note that due to spam issues they are subject to moderation and therefore unlikely to appear immediately. Don't let that put you off though.
Spam never gets published but does make me laugh! Anonymous comments don't get published either.
If you're an engineering company trying to use this blog for free advertising, ask yourself this. What have you got to offer me in return for having your website link published?
And whilst your reading this, everything I post is subject to copyright.